THERMACUT - The Cutting Company

New design solution of the torch Esab®PT-36® allows to change the front part (insulator) of the torch by three screws. This solution decrease the cost of the most defective part of the torch and saves also the time for repair much.

In the case of the front part (insulator) of the torch was necessary to change whole torch in the past. This was forcing to buy new torch and stops the system for hours or days (depends on service availability). New solution of the replaceable insulator allows to change simple way the front part (insulator) of the torch by three screws and continue work in few minutes. Sure that the cost of the new insulator in much lower than new torch.

PT 36 insulator